Specifications

infiNET™ Dimmers Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
Acquire the Dimmer on the infiNET Network
Before an infiNET device can be used on an infiNET network, it must first be
acquired to a C2N-MNETGW gateway that is connected to a Cresnet network.
NOTE: The -DIM1RF, -DIM4RF, -DIMS1RF, and -DIMS4RF can also work as
stand-alone wall box dimmers without being acquired by a C2N-MNETGW.
NOTE: A dimmer can be acquired to only one gateway.
Acquire the Dimmer
To acquire a -DIM1RF/-DIM4RF/-DIMS1RF/-DIMS4RF to a C2N-MNETGW,
perform the following:
1. Put the C2N-MNETGW in the Acquire mode, from the unit itself or from
Crestron Toolbox, as described in the latest revision of the C2N-MNETGW
Operations Guide (Doc. 6317) which is available from the Crestron website
or the Crestron Toolbox help file.
NOTE: In an environment where multiple gateways are installed, only one
gateway should be in the Acquire mode at a time.
2. Place the -DIM1RF/-DIM4RF/-DIMS1RF/-DIMS4RF into the Acquire
mode by doing the following:
a. Move the mode selection switch (located under the LED) to the
“OFF” position.
b. Press and hold the top or bottom of the button on the -DIM1RF/
-DIMS1RF or any button on the -DIM4RF/-DIMS4RF.
c. While holding the button, slide the mode selection switch to the
“RUN” position.
d. Hold the button for approximately five seconds until the LED
flashes HIGH once. Immediately release the button after the LED
blinks to start the dimmer’s Acquire mode.
NOTE: The LED can flash HIGH or LOW. Refer to “LED Behavior” on
page 12 for more information.
NOTE: Holding the button for a significant time after the first flash may
enter other modes. If this is not desired, return the mode selection switch to
the “OFF” position without releasing the button and repeat step 2.
After approximately ten seconds, the LED will start to blink slowly and the
dimmer will attempt to acquire with a C2N-MNETGW that is in the
Acquire mode. The device is acquired when the LED stops blinking and
lights at the LOW setting. After being acquired, the device will exit the
Acquire mode.
The dimmer will be acquired on the C2N-MNETGW with an MNET ID
value of 01. If the dimmer was previously acquired on another infiNET
network, the dimmer will be acquired on the C2N-MNETGW with its
previous MNET ID.
8 • infiNET Dimmers: Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF Operations Guide - DOC. 6396A