Specifications

infiNET™ Dimmers Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
Operation
NOTE: The device may be warm to the touch during operation. This is normal.
Mode Selection Switch
These dimmers use a three-position mode selection switch to set the mode of
operation.
• OFF
When the mode selection switch is in the “OFF” position, the pushbutton(s)
will not have any function and the load is disconnected from the power
source. This must be used when changing light bulbs to ensure that the load
is fully disconnected from power. Slave devices that are connected to the
dimmer will not have any function when the Master’s mode selection switch
is in the “OFF” position.
• RUN
When the dimmer is in the “RUN” position, it is operating in the RUN mode.
This is the normal operating mode of the dimmer. The RUN mode is used to
recall preset light levels and to manually raise and lower the lights.
Refer to the following table for a list of available functions when the dimmer
is operating in the RUN mode.
NOTE: If the behavior of the -DIM4RF/-DIMS4RF has not been changed in
SIMPL™ Windows
®
, SystemBuilder™ or D3 Pro™, the only button that
will perform any function is Button 1. All of the other buttons are
programmable.
RUN Mode Button Functions
FUNCTION -DIM1RF/
-DIMS1RF/
-SLVD1RF
BUTTON PRESS
-DIM4RF/-DIMS4RF
BUTTON PRESS
Dim to Preset 1. Tap the Top button. Tap Button 1. The light
will dim to Preset 1 if the
light level is = 0% (Off).
Dim to Preset 2 in
0.5 seconds.
Double-tap the Top
button.
Double-tap Button 1.
1
Dim to Preset 3 in
0.5 seconds.
Double-tap the Bottom
button.
Double-tap Button 1.
2
Dim to “Full Off”
(lighting level =
0%).
Tap the Bottom button. Tap Button 1. The light
will dim to “Full Off” if
the light level is > 0%
(Off).
Manually raise
light level.
Hold the Top button until
the desired lighting level
is reached.
Hold Button 1 until the
desired lighting level is
reached.
3
Manually lower
light level.
Hold the Down button
until the desired lighting
level is reached.
Hold Button 1 until the
desired lighting level is
reached.
3
1. If load was at Preset 3 level or > 0% (Off), dim to Preset 2.
2. If load was at Preset 2 level, off, or in the process of dimming to off, dim to Preset 3.
10 • infiNET Dimmers: Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF Operations Guide - DOC. 6396A