Specifications

Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF infiNET™ Dimmers
3. The dimmer will not “bounce” at the limit and dim in the opposite direction. If the button is
pressed and held again, the dimmer will dim in the opposite direction. If other events have
occurred since the last “cycle-dim” operation, the dimmer will dim up if the light level was
< 50%. If the light level was ≥ 50%, the dimmer will dim down.
• SET
When the mode selection switch is in the “SET” position, it is operating in
the SET mode. The LED will blink to indicate that the dimmer is in the SET
mode. Refer to the following table for a list of available functions when the
dimmer is operating in this mode.
NOTE: Presets 1 and 2 cannot be programmed to be 0% (Off). Preset 3 can
be set to 0% (Off).
NOTE: The SET mode is only intended for adjusting presets. Under normal
operation, the mode selection switch should be in the “RUN” position.
SET Mode Button Functions
FUNCTION -DIM1RF/-DIMS1RF
BUTTON PRESS
-DIM4RF/-DIMS4RF
BUTTON PRESS
Press and hold the Top
button for five seconds,
the LED will flash HIGH
once. Release the button
to store the current light
level (if > 10%).
Press and hold Button 1
for five seconds, the LED
will flash HIGH once.
Release the button to
store the current light
level (if > 10%).
Store Preset 1.
NOTE: If the light level is greater than 0% (Off), but
less than 10%, the saved preset level will be 10%.
NOTE: If the current light level is equal to 0% (Off),
the LED will not flash, since no save will occur.
Press and hold the Top
button for eight seconds,
the LED will flash HIGH
twice. Release the button
to store the current light
level (if > 0%).
Press and hold Button 1
for eight seconds, the
LED will flash HIGH
twice. Release the
button to store the
current light level (if >
0%).
Store Preset 2.
NOTE: If the light level is greater than 0% (Off), but
less than 10%, the saved preset level will be 10%.
NOTE: If the current light level is equal to 0% (Off),
the LED will not flash, since no save will occur.
Store Preset 3
*
. Press and hold the
Bottom button for five
seconds, the LED will
flash HIGH three times.
Release the button to
store the current light
level (even if the light
level is 0%).
Press and hold Button 1
for 11 seconds, the LED
will flash HIGH three
times. Release the
button to store the
current light level (even if
the light level is 0%).
* DIM4RF/DIMS4RF Only: If the current light level = 0% (Off), the first preset to be stored
will be Preset 3, since Presets 1 and 2 cannot be set to 0%. In this case, the LED will flash
HIGH three times after the button is held for five seconds.
Operations Guide - DOC. 6396A infiNET Dimmers: Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF • 11