User Guide

Crestron CNAMPX-12/16X60 Professional Audio Amplifiers
CAUTION: To prevent stripping of screw heads, threads, or mounting holes, do
NOT overtighten screws. Tighten only to the specification listed in the individual
step(s).
NOTE: The unit shown in this procedure is a CNAMPX-16X60. The procedure is
identical for all models and all versions except where noted.
1. Orient and position the cover onto the CNAMPX-12/16X60.
CAUTION: The cover screws are 1/4-inch except the four screws at the top-center
that are 1/2-inch long. To prevent stripping of screws and/or screw holes, do NOT
interchange the screws.
2. Allow cover to overhang front panel and install top-rear cover screws
(shown on the next page) to finger-tight.
Top-Rear Cover Screws
3. By hand, push cover towards rear panel until the top-front cover screw
holes align.
CAUTION: The four screws at the top-center of the cover are 1/2-inch long. The
remaining cover screws are 1/4-inch. To prevent stripping of screws and/or screw
holes, do NOT interchange the screws.
4. As shown on the next page, install top-center cover screws to finger-
tight.
Service Guide - DOC. 5885B Professional Audio Amplifiers: CNAMPX-12/16X60 • 17