User Guide

Crestron CNAMPX-12/16X60 Professional Audio Amplifiers
7. Orient and position the right-side mounting ear and re-install the three
rack mounting ear screws to finger-tight then, using the 1/8-inch hex
wrench, tighten the screws an additional 1/8-turn.
WARNING: Observe the “Rack Mounting Precautions” on page
2 to install unit
into equipment rack.
WARNING: The CNAMPX-12/16X60 amplifiers are heavy units. The CNAMPX-
12X60 weighs approximately 81.40 lbs (37.00 kg) and the CNAMPX-16X60 weighs
approximately 90.20 lbs (41.00 kg). Use more than one person to install unit into
rack.
8. Using at least two people, install unit into rack.
9. At the rear of the CNAMPX-12/16X60, attach the labeled audio input
and output cables/wires to their respective connectors.
10. Using a #2 Phillips screwdriver, loosen the ground screw, attach the
ground wire, and retighten the screw.
11. Attach the Cresnet system wiring connector to the NET port.
12. Connect the AC power cord to the power port.
13. At the front panel, position the POWER switch to ON.
Service Guide - DOC. 5885B Professional Audio Amplifiers: CNAMPX-12/16X60 19