User Guide

CRESTRON CNCS AC Current Sensor
REMOTE CONTROL SYSTEMS
5 DOC. 8079C
Specifications subject to change without notice.
PROGRAMMING:
A basic CNCS SIMPL program is illustrated in figure 4. The sample program illustrates discrete ON/OFF
for toggle type IR control.
NOTE
The program example is provided as a sample of CNCS implementation and may not
be relevant for every application.
An example follows the figure to illustrate the CRESNET II screen display for CNCS signal assignment.
The "screen saves" in the example are accessible from the "Define Rack" section of the SIMPL-I Menu in
the CRESNET II Workshop and are shown for the CNDIO (which is built-in to the CRESNET II
MiniSystem) and CNIN-16 (which can be inserted into the CRESNET II MiniSystem or RACK).
NAND
ON
FULL-LOAD
ON
EN-OFF
POWER-OFF
BUTTON
FEEDBACK
CNDIO
INPUT
(FOR CNMS)
OR
CNIN-16
(FOR CNRACK)
CNCS
PARTIAL-LOAD
FULL-LOAD
AND
OFF
OFF
BUTTON
AND
POWER-ON
OR
POW
MV
POWER
0.5 S
TRIG OUT
IR
Figure 4. CNCS, SIMPL Program
FURTHER INQUIRIES:
If after reviewing this Operations Guide you still have additional questions, please contact a CRESTRON
technical representative by dialing (888) CRESTRON [[phone]] or [phone].