User Guide

ManualsBrandsCrestron ManualsOtherCNLDM-6-277

Crestron CNLDM-6-277 Six-Channel Dimmer Module

OUTPUT CIRCUITS: 6

OUTPUT RATING: 16 AMP PER CIRCUIT

LOAD TYPES:

INCANDESCENT, NON-DIMMABLE FLUORESCENT,

TWO-WIRE DIMMABLE FLUOURESCENT,

NEON/COLD CATHODE, MAGNETIC LOW VOLTAGE,

FORWARD PHASE ELECTRONIC LOW VOLTAGE

HEAT DISSIPATION: 925 BTU/HOUR WITH ALL CHANNELS AT

MAXIMUM LOAD

INPUT/OUTPUT:

277 VAC, 50-60 Hz, SINGLE PHASE

DIMENSIONS:

HEIGHT: 14.50 in (36.83 cm)

WIDTH: 6.00 in (15.24 cm)

ENCLOSURE: ONE MODULE IN CSTC ENCLOSURE

NETWORK POWER (GREEN) LED &

ACTIVITY (RED) LED

NETWORK ID

SWITCHES

DIM/NON-DIM SELECT

FOR EACH CHANNEL

OVERRIDE SWITCH

BRINGS ALL CHANNELS

TO "FULL ON"

TO CRESTRON CONTROL PROCESSOR.

REFER TO LATEST NETWORK

INTERCONNECT DRAWING (DOC. 5411).

CRESNET COLORS:

24: RED

Y: WHITE

Z: BLUE

G: BLACK

OUTPUT STATUS LEDS

FOR EACH CHANNEL

TIGHTENING TORQUE

8 IN-LB

TO LIGHTS

L DIM

N. BUS

EXTERNAL CIRCUIT BREAKER (20 AMP MAX)

This product is Listed to applicable UL Standards and requirements by Underwriters Laboratories Inc.

(E103692)

Crestron Electronics, Inc. DOC. 6537

15 Volvo Drive (2016636)

Rockleigh, NJ 07647 10.06

Tel: 888.CRESTRON Specifications subject to change without notice.

Fax: 201.767.7576 www.crestron.com

Summary of content (2 pages)

PAGE 1
Crestron CNLDM-6-277 Six-Channel Dimmer Module EXTERNAL CIRCUIT BREAKER (20 AMP MAX) N L DIM TO LIGHTS N. BUS TIGHTENING TORQUE 8 IN-LB OUTPUT STATUS LEDS FOR EACH CHANNEL OVERRIDE SWITCH BRINGS ALL CHANNELS TO "FULL ON" DIM/NON-DIM SELECT FOR EACH CHANNEL NETWORK ID SWITCHES NETWORK POWER (GREEN) LED & ACTIVITY (RED) LED TO CRESTRON CONTROL PROCESSOR. REFER TO LATEST NETWORK INTERCONNECT DRAWING (DOC. 5411).
PAGE 2
Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address.