User Guide

CNX Card Cage System Crestron CNRACKX
22 •• CNX Card Cage System: CNRACKX Operations Guide - DOC. 8133
5b. Set the baud rate to 9600, as shown below.
Changing the Baud Rate from the “Set Baud Rate” Dialog Box
5c. Set the CNRACKX to 9600 baud.
- Depress and hold the SW-R button on the CNRACKX front panel.
- Depress and release the HW-R button on the CNRACKX front
panel.
- Wait until a message similar to the one below appears in the
Viewport.
Viewport Message
CNRACKX Monitor v5.07.00 * 07/14/99 - interupt serial i/o
512k flash memory, 512k NVRAM, segment =FA00
Press <esc> now to enter debug monitor
NOTE: If a computer is not hooked up, wait approximately three to four seconds.
- Release the SW-R button.
5d. If the CNRACKX responds, proceed to step 5e. Otherwise, do the
following.
- Remove power from the CNRACKX.
- Depress and hold the SW-R button on the CNRACKX front panel.
- Reapply power to the CNRACKX.
- Wait until a message similar to the Viewport message above
appears.
NOTE: If a computer is not hooked up, wait approximately three to four seconds.
- Release the SW-R button.
5e. Text messages, as shown below, should appear on the Incoming
Window of the viewport. If messages do not appear or they are
illegible, verify that the viewport is set to 9600 baud and repeat steps 5a
through 5d. If data similar to that shown below appears, perform steps
7 through 11 in “Obtaining Communications” on page 18 before
proceeding to the next step.