Specifications

Isys i/O
®
Tilt Touchpanel Media Center Crestron TPMC-12
Display Output
Touching Display Output shows the display resolution of the touchpanel and
provides test charts for adjusting skew, peak and boost settings on a remote display.
“Display Output” Window
Select the following Test Patterns, in the following order and adjust the display as
necessary.
1. Vertical Lines
2. Grid
3. Color Bars
4. Grayscale Gradient
5. Frequency Adjust Test
6. Streak, Boost and Skew
7. Full Screen White
Update Panel
The Update Panel button permits the selection of the touchpanel program, a .vtz
file. It is also used to upgrade firmware.
The Project tab of the “Project and Firmware” window is divided into two sections:
Current Loaded Project and Load New Project.
In the Target Location to Load the Project to section, you can choose the location
where your uncompressed project files will be stored. The default file location is the
internal flash.
In the Load New Project section, touch Browse and select the compiled project (i.e.
the .vtz file) to be loaded from a network drive, USB device or flash drive, then
touch Open to show the source file in the “Project and Firmware” window. Touch
Load to uncompress the project file, place it in the destination selected in Target
Location to Load the Project to and display it on the touchpanel.
NOTE: If there is a mapped network drive on the touchpanel, the first time you
select Browse, it may take some time for the “Open” window to appear.
24 • Isys i/O
®
Tilt Touchpanel Media Center: TPMC-12 Operations Guide – DOC. 6675A