User Guide

CRESTRON CNWMBG-10A Wall-Mount Wired Panels
REMOTE CONTROL SYSTEMS
2 DOC. 8078
Specifications subject to change without notice.
Preparation for Use
The 4-pin connector marked NET must be wired to the CRESNET II network. Network termination points
are available at the control system power supply. Network units may also be daisy-chained together.
Refer to the latest revision of CNPWS power supplies (Docs. 8017 and 8091) in the CRESNET II manual
for wire gauge specifications and connection detail.
PROGRAMMING:
The panel drawing in figure 1 shows the location of the SIMPL-C button numbers and their corresponding
button positions. Buttons or bargraphs which are not used need not be assigned a signal name.
SYNTAX:
The following syntax codes are provided for compatibility purposes only.
NET.ID <10 to FE>: CNWP
i1,o1 = <signal name> \ button and LED combined
i2 = <signal name> \ independent button
o2 = <signal name> \ independent LED
" = " "
i10 = <signal name>
o10 = <signal name>
<BAR1> = <signal name> \ first bargraph level
FURTHER INQUIRIES:
If after reviewing this Operations Guide you still have additional questions, please contact a CRESTRON
technical support representative by dialing [phone] or [phone].