Crestron DM-RX1-1G Wall Plate DigitalMedia CAT Receiver Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance As of the date of manufacture, the DM-RX1-1G has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC rules.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Contents Wall Plate DigitalMedia CAT Receiver: DM-RX1-1G 1 Introduction ............................................................................................................................... 1 Features and Functions ................................................................................................ 1 Applications.................................................................................................................
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Wall Plate DigitalMedia CAT Receiver: DM-RX1-1G Introduction The DM-RX1-1G which is part of the Crestron® DM® product line, is a DigitalMedia™ CAT receiver that installs in a single-gang electrical box or floor box. It provides one HDMI® output to feed a high definition display or audio processor as part of a complete DigitalMedia system.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G DigitalMedia As the leader in HDMI and control system technologies, Crestron has developed DigitalMedia, the first complete HD AV distribution system that takes HDMI to a higher level, and allows virtually any mix of AV sources to be distributed throughout the home, office, school, or virtually any other facility. DigitalMedia distributes uncompressed digital video and audio signals several hundred feet using DM cable1.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Applications The following diagram shows a DM-RX1-1G in a classroom application. DM-RX1-1G in a Classroom Application Operations & Installation Guide – DOC.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G Specifications Specifications for the DM-RX1-1G are listed in the following table.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver DM-RX1-1G Specifications (Continued) SPECIFICATION Input Resolutions Progressive (Continued) Interlaced Output Resolutions DETAILS 1600 x 1200 @ 60 Hz 1680 x 1050 @ 60 Hz 1920 x 1080 @ 24 Hz (1080p24) 1920 x 1080 @ 25 Hz (1080p25) 1920 x 1080 @ 50 Hz (1080p50) 1920 x 1080 @ 60 Hz (1080p60) 1920 x 1200 @ 60 Hz 2048 x 1080 @ 24 Hz 2048 x 1152 @ 60 Hz Plus any other resolution allowed by HDMI up to 165 MHz pixel clock 720 x 480 @ 30 Hz (480i) 720 x 576 @ 25 H
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G DM-RX1-1G Specifications (Continued) SPECIFICATION DETAILS Audio Input Signal Types Output Signal Types Formats DM CAT HDMI Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby® TrueHD, DTS®, DTS-ES, DTS 96/24, DTS-HD High Res, DTS-HD Master Audio™, up to 8ch PCM Power Requirements DMNet Power Usage 5 Watts (0.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver DM-RX1-1G Specifications (Continued) SPECIFICATION Dimensions Height Width Depth Weight Available Models DM-RX1-1G DM-RX1-1G-W-T DETAILS 4.12 in (105 mm) 1.72 in (44 mm) 2.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G Physical Description This section provides information on the connections, controls and indicators available on your DM-RX1-1G. DM-RX1-1G Physical View 8 • DM® CAT Receiver: DM-RX1-1G Operations & Installation Guide – DOC.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver DM-RX1-1G Overall Dimensions (Front View) 1.72 in (44 mm) 1 4.12 in (105 mm) 2 3 Operations & Installation Guide – DOC.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G DM-RX1-1G Overall Dimensions (Left and Right Views) 4 0.07 in (2 mm) 2.09 in (53 mm) 2.02 in (52 mm) 1.96 in (50 mm) 2.65 in (68 mm) 2.78 in (71 mm) 7 5 6 10 • DM® CAT Receiver: DM-RX1-1G Operations & Installation Guide – DOC.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Connectors, Controls & Indicators 3 RESET BUTTON 4 D2 WH/BLU HDMI OUT BLU 2 (1) Dual-color amber/green LED Amber - indicates operating power supplied via DMNet Green - indicates DM input signal presence/lock status (1) 19-pin Type A HDMI female HDMI digital video/audio output Also supports DVI1 (1) Miniature recessed push button for hardware reset (1) DM CAT input composed of (8) captive screw terminals with (1) grounded strain relief Connects to DM CA
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G 2. Refer to the following table for the D and M terminal block pinouts. D and M Terminal Block(s) 1 2 3 4 5 6 7 8 PIN # WIRE COLOR PIN # WIRE COLOR 1 2 3 4 Brown White/Brown Orange White/Orange 5 6 7 8 Green White/Green Blue White/Blue 3. For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to two DM Repeaters, model DM-DR (sold separately) may be required. Refer to the latest version of the Crestron DigitalMedia Design Guide (Doc.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Setup Network Wiring When wiring the DM network, consider the following: NOTE: DMNet wiring and Cresnet® wiring are not compatible. • Use Crestron Certified Wire. • Use Crestron power supplies for Crestron equipment. • Provide sufficient power to the system. CAUTION: Insufficient power can lead to unpredictable results or damage to the equipment. Use the Crestron Power Calculator to help calculate how much power is needed for the system (www.crestron.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G Installation To prevent overheating, do not operate this product in an area that exceeds the environmental temperature range listed in the table of specifications. To install the DM-RX1-1G, the following tools and accessories are required: • DM-CBL DigitalMedia Cable (sold separately.) Refer to “Network Wiring” on page 13.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver “D” Cable (Stripping the Outer Jacket) 2 1/2 in (64 mm) 1/2 in (13 mm) FoilShield Shield Foil Wire Braid, Twisted Outer Jacket Outer Jacket 4. Trim foil shield to 1/2 inch (13 mm). 5. Remove the white neoprene sheath and separate the twisted pairs to expose the spline. Cut the spline so that it is near flush with the foil shield as shown in the following illustration. Return twisted pairs to original position.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G NOTE: Braid should wind neatly around foil shield. Loose braid may cause shorts. “D” Cable (Wrapping the Twisted Braid) Braid Wrapped Around Foil Shield 7. Strip the insulation from the ends of each wire, exposing approximately 3/16 inch (5 mm) of bare copper. NOTE: Do not allow the twisted pairs to untwist for more than 1/2 inch (13 mm). NOTE: Maintain equal wire lengths within 1/8 inch (3 mm). 8.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Clamping the Cable to the Unit DM-CBL Installs Only from Top of Unit (Or Bottom if Unit is Inverted) Twisted Braid Must Fully Contact Inside of Clamp 9. Strip the outer jacket of the yellow “M” cable 2 inch (51 mm) from end. 10. Strip the insulation from the ends of each wire, exposing approximately 3/16 inch (5 mm) of bare copper. 11. Using an adjustable wrench, clamp the prepared “M” cable to the unit so that the yellow jacket is secured by the clamp.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G 12. Using a miniature flat head screwdriver (not supplied), make the connections as specified, using the labels on the unit as a guide. a. Insert the twisted pairs of the gray DMNet cable into the G B A 24 terminal block and tighten each screw base. Refer to footnote 4 on page 12 for details. G B A 24 Terminal Block G B A 24 b. Insert the twisted pairs of the blue, shielded cable into the D terminal block and tighten each screw base.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver 13. Remove the pre-cut insulation from the grounding wire and connect it to the electrical box or a ground wire in the electrical box (the electrical box must be earth grounded). 14. Attach the unit to the electrical box using the two included #06-32 x 3/4" oval head slotted screws as shown in the illustration below. CAUTION: Excess wire pinched between the unit and electrical box could cause a short.
DigitalMedia™ CAT Receiver Rack Mounting Crestron DM-RX1-1G The DM-RX1-1G can be mounted in a rack with other equipment using the two mounting holes on either corner of the unit. It is assumed the required cable has been installed and wiring has been verified. WARNING: To prevent bodily injury when mounting or servicing this unit in a rack, take special precautions to ensure that the system remains stable.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver DM-RX1-1G Rack Mount (Exploded View) Rack Rail DM-RX1-1G (6503434 or 6504685) Insert (4510566 or 4512253) Rack Mount Screws (Not Supplied) Operations & Installation Guide – DOC.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G Hardware Hookup Make the necessary connections as called out in the illustration that follows this paragraph. Refer to “Network Wiring” on page 13 before attaching the DMNet cable. Apply power after all connections have been made. When making connections to the DM-RX1-1G, use Crestron power supplies for Crestron equipment.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. DM-RX1-1G Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Device does not function. Device is not communicating with the network. Use Crestron Toolbox™ to poll the network. Verify network connection to the device.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G DM-RX1-1G Troubleshooting (Continued) TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION PWR / LINK LED does not illuminate amber. Loss of functionality due to electrostatic discharge. Device is not receiving/ transmitting DMNet signal. Improper grounding. Verify that D and M connections are properly attached. Check that all ground connections have been made properly. NOTE: For more advanced diagnostics, use the DM tool in Crestron Toolbox.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Refer to the following table for commonly used resolutions and maximum DM-CBL cable lengths.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G Reference Documents The latest version of all documents mentioned within the guide can be obtained from the Crestron Web site (www.crestron.com/manuals). This link will provide a list of product manuals arranged in alphabetical order by model number.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G GNU General Public License Version 2, June 1991 Copyright (C) 1989, 1991 Free Software Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA Everyone is permitted to copy and distribute verbatim copies of this license document but changing it is not allowed. PREAMBLE The licenses for most software are designed to take away your freedom to share and change it.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver You may charge a fee for the physical act of transferring a copy and you may at your option offer warranty protection in exchange for a fee. 2.
DigitalMedia™ CAT Receiver Crestron DM-RX1-1G modifying or distributing the Program (or any work based on the Program), you indicate your acceptance of this License to do so and all its terms and conditions for copying, distributing or modifying the Program or works based on it. 6.
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver This page is intentionally left blank. Operations & Installation Guide – DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Installation Guide – DOC. 6969B (2027251) 12.10 Specifications subject to change without notice.
