Specifications

Crestron DigitalMedia™ Design Guide
Check website (www.crestron.com) for product availability 31
DigitalMedia Room Controller
DM-RMC-100 and DM-RMC-100-F
DM-RMC-100
DM-RMC-100-F
The DigitalMedia Room Controllers feature a low profile
design, perfect for installation behind flat panel displays and
above ceiling mounted projectors. The DM CAT version (DM-
RMC-100) mounts on a standard 2-gang or 4 in electrical
box, and extends approximately one inch from the surface.
Connections for the display are all positioned on the bottom
edge of the receiver, while the DM and LAN connections are
made behind the unit within the electrical box.
The DM fiber version, model DM-RMC-100-F, mounts directly
to the wall or ceiling surface, with all connections made along
the top and bottom edges. An external power supply (wall
wart) can be used when using fiber optic cable.
Power and Heat Calculations
The DM-MD8X8 and the DM-MD16X16 both provide 24VDC power for connected DigitalMedia equipment, such as
transmitters, and room controllers, and repeaters. Specifications are as follows:
Max Power
Consumption
Heat Dissipated
(BTU)
Power available
via DMNet
DM-MD8X8 211W 475 55W
DM-MD16X16 376W 792 110W
Room Controller, Repeater, and Transmitter Power Consumption:
 DM-RMC-100 — 6W
 DM-RMC-100-F — 6W
 DM-DR — 3W

DM-TX-100 — 9W
 DM-TX-200 — 12W
 DM-TX-300 — 15W
 DMCI — 12W
If more power is needed for DigitalMedia devices, it can be provided externally using the “EIG” jumpers to bring
in power from a standard 24V Crestron power supply. Refer to the manual for hookup information.