Specifications

Crestron DMPS-100/200/300-C/300-C-AEC DigitalMedia Presentation System
Operations Guide – DOC. 7219E DigitalMedia Presentation Systems: DMPS-100/200/300-C/300-C-AEC
•
43
Program Output
The Program Output section of the “Audio Setup” menu is used to set the program
output source mix, bass, treble, program delay, minimum volume, maximum volume,
startup volume, and stereo/mono settings.
Access the
“Program Output” Menu
Access the “Program Output” menu:
1. Access the “Audio Setup” menu as described on page 41.
2. Press the
 or  buttons until Program Output is displayed on the LCD and
press ENTER to display the “Program Output” menu.
3. To return to the “Audio Setup” menu, press MENU.
Set the Program Source Mix
Set the program source mix:
1. Access the “Program Output” menu as described above.
2. Press the
 or  buttons until Source Mix is displayed on the LCD and press
ENTER to display the “Program Source Mix” menu.
“Program Source Mix” Menu
3. Press the
 or  buttons until the desired setting is displayed on the LCD. The
current setting is indicated with an asterisk (*). The following settings are
available:
• Aud. Only sends the audio signal from the selected source to the PROG
OUT connector.
• Mic. Only sends the microphone input signal to the PROG OUT connector.
• Mic + Aud sends a mix of the audio signal from the selected source and the
microphone input signals to the PROG OUT connector.
NOTE: While setting the program source mix, the program volume level can
be adjusted by turning the VOLUME control clockwise to raise the volume, or
counterclockwise to lower the volume. When adjusting the volume, the display
changes to indicate the volume level.
4. Press ENTER to save changes and return to the previous screen. To cancel
without saving changes, press MENU.
Set the Program Bass Level
Set the program bass level:
1. Access the “Program Output” menu as described above.
2. Press the
 or  buttons until Bass is displayed on the LCD and press
ENTER to display the “Program Bass” menu. The current bass level is
displayed.
“Program Bass” Menu