Specifications

Crestron DMPS-100/200/300-C/300-C-AEC DigitalMedia Presentation System
Operations Guide – DOC. 7219E DigitalMedia Presentation Systems: DMPS-100/200/300-C/300-C-AEC
•
55
4. Press ENTER to move the cursor to the next section of the address. To change a
different section, press the button under the section to be changed.
5. Repeat the previous two steps until the entire IP address is set.
6. To save the new address and return to the “Network Setup” menu, move the
cursor to the right-most section and press ENTER. To cancel the operation and
return to the “Network Setup” menu, press MENU.
Set the Subnet Mask
The DMPS-100/200/300-C can be set up to use an IP subnet mask for TCP/IP
communications. Set the address of the IP subnet mask:
1. Access the Network Setup menu as described above.
2. Press the
 or  buttons until Subnet Mask is displayed on the LCD and press
ENTER to display the “Subnet Mask” menu. The current subnet mask IP
address is shown.
“Subnet Mask” Menu
3. Turn the VOLUME control clockwise or counterclockwise to select a number
in the left-most section of the subnet mask IP address. Numbers can also be
selected by pressing the
 or  buttons.
4. Press ENTER to move the cursor to the next section of the address. To change a
different section, press the button under the section to be changed.
5. Repeat the previous two steps until the entire subnet mask IP address is set.
6. To save the new address and return to the “Network Setup” menu, move the
cursor to the right-most section and press ENTER. To cancel the operation and
return to the “Network Setup” menu, press MENU.
Set the Default Router
The DMPS-100/200/300-C can be set up to use a default router for TCP/IP
communications. Set the IP address of the default router:
1. Access the “Network Setup” menu as described on page 54.
2. Press the
 or  buttons until Def. Router is displayed on the LCD and press
ENTER to display the “Def. Router” menu. The current IP address of the
default router is shown.
“Def. Router” Menu
3. Turn the VOLUME control clockwise or counterclockwise to select a number
in the left-most section of the default router IP address. Numbers can also be
selected by pressing the
 or  buttons.
4. Press ENTER to move the cursor to the next section of the address. To change a
different section, press the button under the section to be changed.
5. Repeat the previous two steps until the entire default router IP address is set.
6. To save the new address and return to the “Network Setup” menu, move the