Specifications

quickstart guide
GL-IPAC-SW8
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
GL-IPAC-SW8
Crestron Green Light
®
Integrated Switching System
The following illustration is a detailed connection overview of a GL-IPAC-SW8 system.
Wiring Diagram
SENSORS 1-4
(24, 1 - 4, G) connects to
occupancy sensors. Use
18 - 12 AWG wiring.
SENSORS 5-8
(24, 1 - 4, G) connects to
photocells. Use 18 - 12
AWG wiring.
24 supplies power to the
devices and should be
daisy chained to all
devices in the same
sensor group.
1 - 4 control signal from
the connected device.
G is the common ground
to the devices and should
be daisy chained to all
devices on the same
sensor group.
CKT 1 is used to power the GL-IPAC-SW8. Line power can be
daisy chained from LN1 to LN2 to LN3 and so on. LN1, LN2
through LN8 can also be powered by individual circuits. Use
14 - 10 AWG wiring.
SENSORS 5-8
24 1 2 3 4 G 24 1 2 3 4 G
SENSORS 1-4
S
3
S
1
S
2
S
3
S
1
S
2
From Neutral Connection
N
N
To Additional Neutral
Connection (Optional)
OVERRIDE (OR G) connects to a
contact closure or a Crestron
GLS-PLS-120/277 Phase Loss
Sensor (sold separately). Use
18 - 12 AWG wiring.
Emergency
Override
OR G
OVERRIDE
CONTACT CLOSURES (1 - 8, G) connects
to contact closures and are configured
through the front panel setup controls. Use
18 - 12 AWG wiring.
CONTACT CLOSURES 1 is reserved to lock
the GL-IPAC-SW8 user interface.
CONTACT CLOSURES 2 is reserved to lock
the keypads.
CONTACT CLOSURES 3 - 8 are configured
through programming.
G is the common ground to the devices and
should be connected to all contact closures.
1 2 3 4 5 6 7 8 G
CONTACT CLOSURES
Lock GL-IPAC-SW8
Programmable
Contact Closure
Lock Keypads
Occupancy Sensors Photocells
LN1
LN1
SW1
LN2
LN2
SW2
To
Switched
Load
From Line
Power
Jumper from CKT 2
to CKT 3 to Power
CKT 3 Loads
LN3
LN3
SW3
From Line
Power
To
Switched
Load
To
Switched
Load
CRESNET (24 Y Z G) is used to power
(24 Vdc) and communicate with
compatible Cresnet devices using
Cresnet cable.
24 Y Z G
CRESNET
Cresnet
Devices
For Regulatory Compliance information, refer to Doc. 7401.
QUICKSTART DOC. 7389B (2036222, Sheet 1 of 7) 01.14
(Continued on following page)