Setup guide

Crestron IPAC-GL1 Integrated Professional Automation Computer
Setup
Installation
For installation instructions, refer to the latest version of the IPAC Installation Guide
(Doc. 6696) which shipped with your IPAC and is also available for download from
the Crestron website (
www.crestron.com/manuals).
After power is applied to the IPAC, the IPAC home page is displayed as shown in
the following illustration.
IPAC Home Page
Setup Guide – DOC. 6660B Integrated Professional Automation Computer: IPAC-GL1 • 5
To return to the home page at any time, press the HOME button.
Configuration
The instructions contained in this document are written for version 1.2.1 of the
IPAC-GL1 Default Program. To verify your version, press the HOME button.
The version number is displayed in the lower-right part of the display.
If the default program is not to be used, refer to “Appendix A: Programming
Software” on page 55 for information on programming the IPAC with Crestron
programming tools.
The following table lists the specifications for the IPAC-GL1 Default Program.
Refer to “Appendix C: Specifications” on page 60 for additional specifications.
Specifications for the IPAC-GL1 Default Program
SPECIFICATION DETAILS
Maximum number of
supported panels
9 GLEP enclosures with GLXP Power Switching
Modules
Maximum number of
controlled loads
210 switched loads
(Continued on following page)
Setup TmClk
Crestron IPAC
Octobe
r
20, 2009
20
4: PM
V1.2.1