Installation guide
7.1 High-Definition Professional Surround Processor Crestron HD-XSP
28 • 7.1 High-Definition Surround Processor: HD-XSP Operations & Installation Guide – DOC. 7446A
“Startup Volume” Screen
Startup
Volume
0%
3. Press ∧ or ∨ to adjust the minimum volume level and press SELECT. The
display returns to the previous menu.
To cancel and return to the previous menu, press BACK.
To enable or disable the startup volume setting, refer to “Use/Ignore Startup
Volume” below.
Use/Ignore Startup Volume
(Theater & Downmix Output)
The startup volume setting can be enabled or disabled. When the startup volume
setting is ignored, the last volume setting is used. To set the output:
1. Select the output to configure as described in “Configure Outputs” which
starts on page 25.
2. Press ∧ or ∨ to highlight Startup Volume: Use or Startup Volume: Ignore
and press SELECT. The setting toggles between “Use” and “Ignore”.
Configure Network
Ethernet settings for the HD-XSP are set from the Network section of the “Installer”
menu. To configure the Ethernet settings:
1. Open the “Installer” menu as described in “Open “Installer” Menu” on page
23.
2. Press ∧ or ∨ to highlight Network and press SELECT. The “Network”
menu is displayed.
“Network” Menu
Network
Status
DHCP: On
IP Address
Subnet Mask
3. Press ∧ or ∨ to highlight the parameter to view or configure and press
SELECT.
Status
Details of the HD-XSP’s Ethernet connection can be viewed from the Status section
of the “Network” menu. To view this information:
1. Open the “Network” menu as described in “Configure Network” above.
2. Press ∧ or ∨ to highlight Status and press SELECT. The “Network Status”
menu is displayed.