Installation guide

7.1 High-Definition Professional Surround Processor Crestron HD-XSP
30 7.1 High-Definition Surround Processor: HD-XSP Operations & Installation Guide DOC. 7446A
“IP Address” Screen
IP Address
[10].0.0.111
3. Press or to set the first octet of the IP address.
4. Press < or > to move the cursor between octets (or press SELECT to move
to the next octet) to select for editing.
5. Repeat steps 3 and 4 for each octet.
6. To save the IP address and return to the “Network Setupmenu, move the
cursor to the rightmost octet and press SELECT. To cancel the operation
and return to the previous screen, press BACK.
If any changes were made, the HD-XSP reboots upon exiting the “Installer”
menu.
Subnet Mask
The subnet mask can be manually set or obtained from a DHCP server. For
information on enabling DHCP to obtain a subnet mask, refer to “
Enable/Disable
DHCP” on page 29.
NOTE: If DHCP is enabled, any changes made do not take effect.
To manually set the subnet mask:
1. Open the “Network” menu as described in “Configure Network” on page
28.
2. Press or to highlight Subnet Mask and press SELECT.
If DHCP is enabled, the subnet mask and a message stating “DHCP On:
Address Invalid” is displayed. Otherwise, controls for setting the subnet
mask are displayed in the “Subnet Mask” screen.
“Subnet Mask” Screen
Subnet Mask
[255].255.255.0
3. Press or to set the first octet of the subnet mask.
4. Press < or > to move the cursor between octets (or press SELECT to move
to the next octet) to select for editing.
5. Repeat steps 3 and 4 for each octet.