User Guide

FlipTop Control Center with Cresnet
®
Crestron C2N-FTB
The cable management plate must be installed before mounting the C2N-FTB to
a surface. The cables are looped through the cable support plate.
A Phillips screwdriver is required to install the cable management plate.
1. Place the bushings on the cables (eight bushings supplied).
2. Thread the cables through the appropriate slot on the plate.
3. Snap the bushings into the plate slots. The bushings protect the cables
from chafing against the metal edge of the plate.
4. Feed all the excess cable through the opening.
5. Use a Phillips screwdriver to attach the plate with the four #4-40 x ¼”
black screws.
6. The cables may be secured to the bottom bar using tie wraps (not
supplied).
Cable Management Plate Installation
When selecting cables for installation in the C2N-FTB, cable connector length
and strain relief diameter are important considerations.
• If the connector is too long, it can interfere with cover operation and
scratch the buttons.
• If the width of the cable strain relief is too similar to the bushing inside
diameter, the bushing can trap the cable.
NOTE: Do not use the cable management plate without the bushings.
12 • FlipTop Control Center with Cresnet
®
: C2N-FTB Operations & Installation Guide - DOC. 6338