User Guide

Crestron C2N-IRGW-1G IR Gateway/Receiver
Transmitter” window) corresponds to each physical press on the universal remote.
This procedure picks up where the code verification procedure left off.
1. Complete steps 1 through 6 in “Code Verification” on page 9.
2. Wherever convenient (i.e., Notepad on the PC or a piece of scrap
paper) create a table for recording the Button ID (Decimal) number
associated with each button press on the universal remote. “Appendix:
Mapping Table” on page 19 contains a table to record this information.
Create as many copies of the table as necessary.
3. Click the Clear button in the “Identify Transmitter” window to reset
the setup.
4. Press a single button on the universal remote and observe the “Identify
Transmitter” window.
5. Record the button title and ID for the action in step 4.
6. Repeat steps 4 and 5 for each button that is to be mapped. Refer to the
sample after this step.
Sample of Completed Mapping Table
7. Repeat this entire procedure (steps 2 through 6) for each source
selection button on the universal remote that requires programming.
Operations & Installation Guide – DOC. 6468 IR Gateway/Receiver: C2N-IRGW-1G • 11