User Guide

Shade & Drape DC Motor Controller Crestron C2N-SDC-DC

The PC communication settings specified here should match

the protocol that the control processor expects. The usual

settings are as follows.

• Port = COM 1 through COM 8. Select the correct COM

port on the PC.

• Baud rate = Auto-Detect (or 115200).

• Parity = None.

• Number of data bits = 8.

• Number of stop bits = 1.

• Hardware handshaking (RTS/CTS) enabled.

• Software handshaking (XON/XOFF) not enabled.

“Address Book” Window – Serial Setup

4. After setting the correct parameters, click OK to return to the

Crestron Toolbox main window.

5. Click Tools | Network Device Tree, or click the network

device tree icon

to display the devices in the system.

y Shade & Drape DC Motor Controller: C2N-SDC-DC Operations & Installation Guide - DOC. 6373