User Guide

Crestron C2N-SDC Shade & Drape Motor Controller

Shade & Drape Motor Controller:

C2N-SDC

Introduction

Features & Functions

The Crestron



C2N-SDC is a shade and drape motor control Cresnet

slave module designed to control two bi-directional 1/3 HP motors that

drive shades and drapes. The C2N-SDC is specifically designed for the

Cresnet control network and functions as part of a complete Crestron

control/automation system. Low voltage input power for the control

electronics is derived from the Cresnet +24 VDC supply. Two 4-pin

terminal block connectors are provided so that units can be daisy-

chained.

Functional Summary

• Controls two shade or drape motors individually or

simultaneously

• Each motor may be up to a maximum of 7.5 A

(1/3 horsepower)

• The C2N-SDC fits inside a standard 2-gang or

4” square electrical box

• Manual pushbutton control is provided on the faceplate

The C2N-SDC is designed to fit inside and mount to a 2-gang wall box or

4”x 4” x 1.5” electrical box, where input power for the two shades or

drapes is derived from mains wiring. Pigtail wires attached to the rear of

the unit provide wire connections for 120 VAC and ground.

Operations & Installation Guide - DOC. 6316 Shade & Drape Motor Controller: C2N-SDC •