User Guide

Shade & Drape Motor Controller Crestron C2N-SDC

Two 4-pin terminal blocks for motor connections accommodate up to

14 AWG wire. Each shade or drape has connections for up drive, down

drive, common (neutral), and chassis ground (if available). Hardware

prevents both the open and close motors from operating simultaneously.

Also, firmware logic provides a minimum time delay so that both the

open and close motors are off for a short period of time when the

directions are reversed. Additional control is available via Cresnet.

Four pushbuttons on the face of the unit allow the motors to be activated

without Cresnet control, which is particularly useful when operating the

unit locally during installation.

Specifications

The following table summarizes the specifications for the C2N-SDC.

Specifications of the C2N-SDC

SPECIFICATION DETAILS

Cresnet Power Usage 3 Watts (0.125 Amps @ 24 VDC)

Default ID 0E

Control System Update

Files

1, 2, 3

2-Series Control System

CNMSX-AV/PRO

CNRACKX/-DP

CEN/CN-TVAV

Version 3.117.CUZ or later

Version 5.14.02X.UPZ or later

Version 5.12.63W.UPZ or later

Version 5.12.63V.UPZ or later

Firmware Version C2N-SDC.v1.0.upg

Motor Input Power 120 VAC, 50/60 Hz, Single Phase

Load Types 3-wire Bi-directional Motor

Maximum Load per Motor 2 x 1/3 HP, 7.5 Amps per channel

(15 A maximum total)

Operating Temperature 41º to 122ºF (5º to 50ºC)

Continued on the following page

• Shade & Drape Motor Controller: C2N-SDC Operations & Installation Guide - DOC. 6316