User Guide

FlipTop Media Center with Storage Compartment Crestron QM-FTMCSC
Button Installation
To replace the large buttons with small buttons, follow this procedure.
A 1/16" Allen (hexhead) wrench is required to remove the button faceplate.
1. Remove the four Allen screws that secure the button faceplate.
2. While holding adjacent buttons in place, carefully pull the button(s) to
be replaced from the rubber membrane.
3. Carefully press the two small replacement buttons in place, making
sure LED window faces up. Use care not to dislodge the membrane and
circuit board.
NOTE: The removable buttons fit snugly on the rubber membrane. Remove
carefully to avoid pulling the membrane from the unit.
4. The divider bar slips into the slots on the back of the faceplate.
5. Replace the faceplate.
Button Installation
Cable Management Plate
The QM-FTMCSC is shipped with a cable management plate. Use the following
instructions for installation.
Parts Supplied with Cable Management Plate
PART DESCRIPTION QUANTITY
Small Cable Bushing, 5/16 inch ID, 0.5 inch OD 2
Large cable Bushing, 0.55 inch ID, 0.80 inch OD 1
Cable Support Plate 1
Tie Wrap 3
Computer RGB Cable, VGA to VGA, 6 ft long 1
Computer Audio Cable, 3.5 mm Stereo, 6 ft long 1
#4 x 1/4 LG black mounting screws 4
18 • FlipTop Media Center with Storage Compartment: QM-FTMCSC Operations & Installation Guide - DOC. 6307A