Crestron MP-AMP30 Media Presentation Audio Amplifier Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance As of the date of manufacture, the MP-AMP30 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC rules.
Crestron MP-AMP30 Media Presentation Audio Amplifier Contents Media Presentation Audio Amplifier: MP-AMP30 1 Introduction ............................................................................................................................... 1 Features and Functions ................................................................................................ 1 Applications.................................................................................................................
Crestron MP-AMP30 Media Presentation Audio Amplifier Media Presentation Audio Amplifier: MP-AMP30 Introduction The Crestron® MP-AMP30 provides a convenient, low-cost audio amplifier solution for a variety of applications. A perfect complement to the entire Media Presentation line from Crestron, it features a compact surface-mountable design that installs virtually anywhere without requiring an equipment rack.
Media Presentation Audio Amplifier Crestron MP-AMP30 Installation and setup of the MP-AMP30 is simple. Detachable output connectors facilitate the termination of speaker wiring up to 16 gauge. RCA inputs connect directly to the line output of a video projector or display, audio processor, mixer, or AV switcher. Rotary controls provide for adjusting the overall speaker volume, as well as bass and treble.
Crestron MP-AMP30 Media Presentation Audio Amplifier MP-AMP30 Specifications (Continued) SPECIFICATION DETAILS Environmental Temperature 41º to 104º F (5º to 40º C) Humidity 10% to 90% RH (non-condensing) Heat Dissipation 21 BTU/Hr Enclosure Chassis Aluminum w/polycarbonate label overlay and four integral mounting flanges Mounting Freestanding or surface mount Dimensions Height 5.85 in (149 mm) Width 3.91 in (100 mm) Depth 1.43 in (37 mm) Weight 11.
Media Presentation Audio Amplifier Crestron MP-AMP30 MP-AMP30 Overall Dimensions 4 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC.
Crestron MP-AMP30 Media Presentation Audio Amplifier Connectors, Controls & Indicators # CONNECTORS*, CONTROLS & INDICATORS DESCRIPTION 1 BASS Control Rotary low frequency boost/cut adjustment, flat at center detent 2 TREBLE Control Rotary high frequency boost/cut adjustment, flat at center detent 3 VOL Control 4 AUDIO OUT 8Ω, R, L +- +R 5, 6 L AUDIO IN L R Rotary input level adjustment (2) 2-pin 3.
Media Presentation Audio Amplifier Crestron MP-AMP30 Setup Installation Mount the MP-AMP30 to a flat surface near the audio source equipment, using four screws (not supplied). Hardware Hookup Hardware Connections for the MP-AMP30 Before applying power, do the following: 1. Make sure the shunt jumpers are properly positioned for stereo (ST) or mono (MO) audio. (Refer to diagram on unit.) 2. Connect all input and output cables (refer to the above illustration). 3.
Crestron MP-AMP30 Media Presentation Audio Amplifier Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. MP-AMP30 Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Power LED does not illuminate. MP-AMP30 is not receiving power. Verify that the power supply is connected and turned on. Audio is distorted or not present at speakers.
Media Presentation Audio Amplifier Crestron MP-AMP30 Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
Crestron MP-AMP30 Media Presentation Audio Amplifier This page is intentionally left blank. Operations & Installation Guide – DOC.
Media Presentation Audio Amplifier Crestron MP-AMP30 This page is intentionally left blank. 10 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC.
Crestron MP-AMP30 Media Presentation Audio Amplifier This page is intentionally left blank. Operations & Installation Guide – DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide – DOC. 6917B (2025921) 05.10 Specifications subject to change without notice.