User Guide

Software Crestron Serial Mouse Control Driver
1. Using the Crestron Viewport, (Remote | TCP/IP | Connect or Remote | Remote
Console | Connect) establish communication with the touchpanel.
2. As shown on the next page, use the ipt (IPTABLE) command to display the
current IP table for the CIP interface on the touchpanel.
IP Table
3. As shown below, using the addm (ADDMASTER) command to add a CIP node
to the master list of the touchpanel, enter the information in the following format
with spaces (no period or underscore) between the entries: CIP ID from SIMPL
Windows (example of 4 is shown), IP address of touchpanel (example of
132.149.010.147 is shown), and Device ID (example of 4 is shown).
NOTE: The Device ID of the Serial Mouse Control Driver MUST match the CIP ID and
will also be used in step 6 of “VT Pro-e Programming” that begins on page 16.
Add Device ID to Table
12 • Serial Mouse Control Driver Programmer’s Guide - DOC. 5916A