Specifications

PROCISE™ Surround Sound Processor Crestron PSPHD
Pair Crestron Amplifier
NOTE: Pairing is for use with Crestron PROAMP amplifiers only.
The PSPHD can be paired with a Crestron PROAMP amplifier for control and
monitoring of the amplifier. Pairing can be accomplished when the PROAMP
amplifier and the PSPHD are connected using a “Network” or “Direct” connection
type:
• Network:
When using a “Network” connection type, the PSPHD is connected to a
PROAMP amplifier over a local area network as shown in the following
diagram.
PSPHD
PROAMP
Control
System
Ethernet
The “Network” connection type can be used if you already have a DHCP
network available and plan to control the PROAMP-7X400 and PSPHD
over a LAN. To pair the PSPHD with a PROAMP amplifier using a
“Network” connection:
1. Turn off the PROAMP amplifier.
2. Using the NETWORK/DIRECT switch on the rear of the PROAMP
amplifier, set the connection type to NETWORK.
3. Power on the PROAMP amplifier.
NOTE: If you change the position of the NETWORK/DIRECT
switch again on the PROAMP-7X400, you must then power cycle the
device in order for the new setting to take effect.
4. On the PSPHD, open the Network Setup section as described on page
35.
5. Turn the selection knob until “Pair Crestron Amplifier” is displayed.
Press the selection knob to open the Amplifier Pairing Control.
Amplifier Pairing Control
AMPLIFIER PAIRING
Crestron Amplifier Connection
Network Direct
SOURCE MODE SETUP INFO
6. Turn the selection knob to highlight Network as the connection type
between the PSPHD and the PROAMP amplifier.
36 • PROCISE™ Surround Sound Processor: PSPHD Operations Guide – DOC. 6837B