Specifications

Crestron PSPHD PROCISE™ Surround Sound Processor
NOTE: The PSPHD and the PROAMP amplifer must be set to the
same connection type.
NOTE: When using the “Network” connection type, the PSPHD and
the PROAMP amplifier must be on the same subnet.
7. Press the selection knob to select the “Network” connection type.
8. When prompted, press either of the following buttons on the PROAMP
amplifier while the appropriate LEDs blink (about two minutes):
• RESET (front panel). Press this button while the front panel LEDs
blinks.
• OVERRIDE/SETUP (rear panel). Press this button while the red
OVERRIDE/SETUP LED blinks.
NOTE: If the RESET or OVERRIDE/SETUP button is not pressed
within two minutes, the LEDs stop blinking and the PSPHD display
returns to the Network Setup section.
9. When the PSPHD is successfully paired with the PROAMP amplifier, a
message is displayed indicating the successful pairing.
10. On the PSPHD, press the selection knob to exit. The display will return
to the Network Setup section.
11. Reboot the PSPHD as follows:
a. Press the HOME button to return to the Installer menu.
b. Turn the selection knob until Exit Installer Mode is displayed and
then press the selection knob.
• Direct:
When using a “Direct” connection type, the PSPHD is directly connected to
the PROAMP amplifier as shown in the following diagram.
The “Direct” connection type can be used for a quick installation test
without networking or LAN setup. The LAN port of the PSPHD connects
directly to the LAN port of the PROAMP amplifier. To later integrate with
a control system program controlling via the LAN, the pairing process must
be executed again when the PSPHD and PROAMP amplifier are installed
on a network. If the PSPHD and PROAMP amplifier are to be controlled by
Cresnet, pairing does not need to be repeated. To pair the PSPHD with a
PROAMP amplifier using a “Direct” connection:
1. Turn off the PROAMP amplifier.
2. Using the NETWORK/DIRECT switch on the rear of the PROAMP
amplifier, set the connection type to DIRECT.
3. Power on the PROAMP amplifier.
Operations Guide – DOC. 6837B PROCISE™ Surround Sound Processor: PSPHD • 37