Specifications

PROCISE™ Surround Sound Processor Crestron PSPHD
3. Turn the selection knob to highlight the desired setting and press the
selection knob to enable the setting and return to the Control Setup section.
For more information on assigning Net IDs, refer to “Identity Code” on page 24.
IP ID
An IP ID for control system communication over TCP/IP can be assigned from the
PSPHD’s front panel. To assign an IP ID:
1. Open the Control Setup section as described on page 42.
2. Turn the selection knob until the PSPHD’s IP ID is displayed. Press the
selection knob to open the IP ID control.
IP ID Control
CONTROL SETUP
03
SOURCE MODE SETUP INFO
3. Turn the selection knob to highlight the desired setting and press the
selection knob to enable the setting and return to the Control Setup section.
NOTE: If an IP ID is set, Cresnet communications with the PSPHD are
disabled.
For more information on assigning IP IDs, refer to “Identity Code” on page 24.
IP Table
The PSPHD uses an IP table for TCP/IP communication with a Crestron control
system. The IP table contains the IP address or hostname of the Crestron control
system that is communicating with the PSPHD. To specify the control system:
1. Open the Control Setup section as described on page 42.
2. Turn the selection knob until the PSPHD’s IP table entry is displayed. Press
the selection knob to open the IP Table control.
IP Table Control
CONTROL SETUP
IP Table Entry Currently Uses an IP Address
Choose A Format To Overwrite It
IP Address Hostname
SOURCE MODE SETUP INFO
3. The control system can be specified by IP address or the hostname. To
specify the control system by:
44 • PROCISE™ Surround Sound Processor: PSPHD Operations Guide – DOC. 6837B