Specifications

Crestron PSPHD PROCISE™ Surround Sound Processor
Operation
Turn on the PSPHD
To turn on the PSPHD, press STANDBY, SOURCE, MODE, SETUP, INFO,
HOME, METER, SPECTRUM, or LEVEL.
NOTE: Until Audyssey calibration has been performed, the PSPHD front panel will
show a message every few seconds indicating that the system should be calibrated.
Standby
To place the PSPHD in the Standby mode press STANDBY. The display and outputs
will be turned off and the STANDBY LED will light.
Home
Press HOME to return to the home display. The selected source (with Decoding
mode) and volume level will be displayed.
Display Brightness
The display has four levels of brightness. Press DISPLAY to cycle through the
brightness settings.
Volume Control
Use the volume knob to adjust the volume level. To raise the volume, turn the knob
clockwise. To lower the volume, turn the knob counterclockwise. The volume level
is displayed in the right-hand display.
Mute
To mute the PSPHD’s audio outputs, press the MUTE button. The associated LED
will light. To unmute, press the MUTE button. The associated LED will extinguish.
Select a Source
The PSPHD can select one of 27 sources for listening.
NOTE: If a source’s name has been deleted with the PROCISE Tools, it will not be
displayed.
To select a source:
1. Press the SOURCE button.
2. Turn the selection knob until the desired source is displayed.
3. Press the selection knob to select the selection.
4. Press HOME to return to the home display.
Operations Guide – DOC. 6837B PROCISE™ Surround Sound Processor: PSPHD • 53