Specifications

PROCISE 7.3 Surround Sound Processor Crestron PSPHD
36 • PROCISE 7.3 Surround Sound Processor: PSPHD Operations Guide – DOC. 6837C
Pair Crestron Amplifier
NOTE: Pairing is for use with Crestron PROAMP amplifiers only.
The PSPHD can be paired with a Crestron PROAMP amplifier for control and
monitoring of the amplifier. Pairing is accomplished when the PROAMP amplifier
and the PSPHD are connected using a “Network” or “Direct” connection:
• Network:
When using a “Network” connection, the PSPHD is connected to a
PROAMP amplifier over a local area network as shown in the following
diagram.
PSPHD Paired with a PROAMP Amplifier over a Network
The “Network” connection can only be used if there is a DHCP network
available and the PROAMP amplifier and PSPHD are to be controlled over a
LAN. To pair the PSPHD with a PROAMP amplifier using a “Network”
connection:
1. Turn off the PROAMP amplifier.
2. On the PROAMP amplifier, set the NETWORK/DIRECT switch to
NETWORK.
3. Apply power to the PROAMP amplifier.
NOTE: If the NETWORK/DIRECT switch setting on the PROAMP
amplifier is changed, power must be cycled for the new setting to take
effect.
4. On the PSPHD, open the “NETWORK SETUP” menu as described on
page 35.
5. Turn the selection knob until Pair Crestron Amplifier is displayed and
press the selection knob to display the “AMPLIFIER PAIRING” screen.