Specifications

PROCISE 7.3 Surround Sound Processor Crestron PSPHD
38 • PROCISE 7.3 Surround Sound Processor: PSPHD Operations Guide – DOC. 6837C
PSPHD Paired Directly with a PROAMP Amplifier
The “Direct” connection can be used for a quick installation test without
networking or LAN setup. The LAN port of the PSPHD connects directly to
the LAN port of a PROAMP amplifier. At final installation, the pairing
process must be executed again when the PSPHD and PROAMP amplifier
are installed on a network. If the PSPHD and PROAMP amplifier are to be
controlled by Cresnet, pairing does not need to be repeated. To pair the
PSPHD with a PROAMP amplifier using a “Direct” connection:
1. Turn off the PROAMP amplifier.
2. On the PROAMP amplifier, set the NETWORK/DIRECT switch to
DIRECT.
3. Apply power to the PROAMP amplifier.
NOTE: If the NETWORK/DIRECT switch setting on the PROAMP
amplifier is changed, power must be cycled for the new setting to take
effect.
4. On the PSPHD, open the “NETWORK SETUP” menu as described on
page 35.
5. Turn the selection knob until Pair Crestron Amplifier is displayed and
press the selection knob to display the “AMPLIFIER PAIRING” screen.
“AMPLIFIER PAIRING” Screen
AMPLIFIER PAIRING
Crestron Amplifier Connection
Network Direct
SOURCE MODE
SETUP INFO
6. Turn the selection knob to highlight Direct and press the selection knob.
NOTE: The PSPHD and the PROAMP amplifier must be set to the
same connection type.