Installation guide

Crestron QM-WMC/WMC-VCC/WCC-2 Media & Computer Centers
NOTE: All Crestron certified Cresnet wiring must consist of two twisted
pairs. One twisted pair is the +24V conductor and the GND conductor and
the other twisted pair is the Y conductor and the Z conductor.
Strip and Tin
Wire
When daisy-chaining Cresnet units, strip the ends of the wires carefully to
avoid nicking the conductors. Twist together the ends of the wires that share
a pin on the network connector and tin the twisted connection. Apply solder
only to the ends of the twisted wires. Avoid tinning too far up the wires or
the end becomes brittle. Insert the tinned connection into the Cresnet
connector and tighten the retaining screw. Repeat the procedure for the
other three conductors.
Add Hubs
Use of a Cresnet Hub/Repeater (CNXHUB) is advised whenever the
number of Cresnet devices on a network exceeds 20 or when the combined
total length of Cresnet cable exceeds 3000 feet (914 meters).
Reference Documents
The latest version of all documents mentioned within the guide can be
obtained from the Crestron website (www.crestron.com/manuals
). This
link will provide a list of product manuals arranged in alphabetical order
by model number.
List of Related Reference Documents
DOCUMENT TITLE
2-Series Control Systems Reference Guide
MediaManager Applications Guide
QM-RMCRX-BA Room Media Controller
and QuickMedia Receiver
QM-WMIC Microphone Input Module
Further Inquiries
If you cannot locate specific information or have questions after
reviewing this guide, please take advantage of Crestron's award winning
customer service team by calling Crestron at 1-888-CRESTRON
[1-888-273-7876].
Operations & Installation Guide – DOC. 6237C Wall Plate Media & Computer Centers • 39