User Guide

Wall Plate Media Center Crestron QM-WMC
NOTE: The following is the acceptable file extension for a firmware
update file:
.upg QM-WMC.V.XXXXX.upg (wall plate firmware)
1. Make sure that “Communication Settings,” which begins on
page 35, has been performed.
2. As shown after this step, select File Transfer | Load
Network Device… from the Viewport menu bar.
File Transfer | Load Network Device… Command
3. As shown in the “Select Network ID” window, select the Net
ID of the QM-WMC, and then click OK. The “Open” window
appears (refer to the following graphics).
“Select Network ID” Window
40 • Wall Plate Media Center: QM-WMC Operations & Installation Guide - DOC. 6237A