User Guide

Crestron UPX-2 Universal Presentation Processor
Analog Values for Output Selection
ANALOG VALUE VIDEO OUTPUT TYPE
0 Same as Output A
1 RGB_1
2 RGB_2
3 HDTV_1
4 SVIDEO_1
5 SVIDEO_2
6 CVBS_1A
7 CVBS_1B
8 CVBS_1C
9 CVBS_2A
10 CVBS_2B
11 CVBS_2C
12 YPBPR_1
13 YPBPR_2
14 None
To display annotation, embedded applications, and multiple video
sources from output A to output B, use an analog value of zero to the
analog join 25.
NOTE: If popup windows are displayed on output A and if the “Show
To Display Output” digital join assigned in VT Pro-e is held high, the
popup window will be displayed identical to display output A.
NOTE: If popup windows are displayed on output A and if the “Show
to Display Output” digital join signal is low, then the popup window
will be hidden from display output B when it is on a video/rgb window
and displayed black when it is on graphics, such as an embedded
applications or a page.
Picture-In-Picture (PIP)
With multiple sources available to the user, a project including PIP can be created to
preview connected sources. To use PIP in a VT Pro-e project, the following
conditions must be met:
• PIP must be set to the top layer in VT Pro-e at design time.
• The PIP source cannot be simultaneously displayed full-screen on display
output B.
• PIP can only be displayed on the local touchpanel but not display output B
unless under annotation mode in which both outputs would be identical.
• A PIP window will have a black border when it is displayed.
Translucent Objects
Translucency allows any object in a project to be seen through. This object property
is selected in VT Pro-e.
Reference Guide - DOC. 6286A Universal Presentation Processor: UPX-2 • 17