Specifications

CRESTRON
The macro in this sample
shall address MAIN-UNIT-2
and select ZONE-1-UP.
8. A macro is created by adding the appropriate commands and delays as
required. Click the Insert Command button to open the “Device
Functions” dialog box.
8. Highlight the ST-LT in the Device area to display the associated
functions in the right-hand column.
9. Select MAIN-UNIT-2 as the desired function. The dialog box should
appear as shown below; click OK.
Device Functions Dialog Box
11. The software returns to the “Macro Edit” dialog box. Notice that the
first step of the macro addresses MAIN-UNIT-2. Click on Insert
Command, ZONE-1-UP from the Function area, and OK. Once the
macro is complete, select OK to close the “Macro Edit” dialog box.
12. Next, the function must be assigned to a specific button on the lighting
page. With the lighting page open, right-mouse click on the ZONE 1
UP button and select Function from the pop-up.
13. The software displays the “Function” dialog box for that given button.
Click on the [Macro:] field and select ZONE1-UP. The dialog box
should appear as shown below; click OK.
Function Dialog Box
14. Additional macros should be created and assigned for each button on
the lighting page that provides a function. Therefore, repeat steps 6
through 13 for the appropriate buttons.
12 • Lutron Interface Operations Guide - Doc. 5694