Specifications

Crestron STRFGWX Two-Way RF Transceiver
“Select Network ID” Dialog Box
8. As shown below, select the downloaded firmware (UPG) file and
click Open. The transfer will complete automatically.
“Select Firmware” Dialog Box
NOTE: During the next step, do not interrupt power until the message is displayed.
If the LEDs blink sporadically and the unit does NOT report the new version,
disconnect the power and contact a Crestron customer support representative.
NOTE: In the message in the next step, 7D and chan a have been user defined.
9. When the transfer is complete, observe the blinking RX and TX
front panel LEDs. The LEDs will blink for 20 seconds, turn off for
10 seconds, and blink again for 20 seconds. Press F4 to verify
completion of the process. The unit will report the message below
in the Viewport.
7D: STRFGWX [2.4.1] RF chan a PIC Ver 22.
NOTE: When the firmware of the STRFGWX is upgraded, the associated
touchpanel(s) must also be upgraded. The units will not function properly if not
upgraded with compatible firmware.
10. If the touchpanel firmware upgrade HAS been completed, close
the Viewport, exit SIMPL Windows or VT Pro-e, and disconnect
the programming cable from the PC and the control system.
If NOT completed, perform the touchpanel firmware upgrade
utilizing the firmware (CSF) file included with the download.
Refer to the latest revision of the Operations Guide for the
appropriate touchpanel for the firmware upgrade procedure. The
latest version of the Operations Guides can be obtained from the
Downloads page (MANUAL Library) of Crestron’s website
(www.crestron.com)
. New users are required to register in order to
obtain access to the FTP site.
Operations Guide - DOC. 5811A Two-Way RF Transceiver: STRFGWX • 11