Specifications

Crestron STRFGWX Two-Way RF Transceiver
12 VDC .5 A
This direct current (DC) power socket connector is used to supply power via the
external power pack. Crestron recommends specific power packs for its devices. The
supplied power pack for the STRFGWX is Crestron part number PW-1205
(PWI-1210 for international use). If a power pack other than this Crestron model is
obtained, verify that it meets the required specifications and polarity as shown after
this paragraph.
Power Pack Specifications
CRESTRON POWER PACK INPUT SPECS OUTPUT SPECS
PW-1205 120VAC~60 hertz (Hz) 12VDC .5A
PWI-1210 230VAC~50Hz 12VDC 1A
Power Pack Output Connector Polarity
NET (Modular Cresnet)
These two 6-pin, 6-position RJ11 modular jacks are used to connect the STRFGWX
to modular devices in the Cresnet system. Two NET ports are available so that
network units can be daisy-chained together.
NOTE: Most 6-conductor telephone cables are wired in a crisscross fashion and are
not compatible with Crestron equipment.
NOTE: All NET connectors, the two modular and the four-wire, can be used
simultaneously.
NET (Four-Wire Cresnet)
This 4-pin connector is used to connect the STRFGWX to other four-wire devices in
the Cresnet system.
STRFGWX Indicators
There are five LED indicators located on the front panel of the STRFGWX. Refer to
the diagram below and the descriptions on the next page. The front panel also has a
connector where the supplied antenna is attached. The antenna transmits and receives
the touchpanel RF signals.
STRFGWX Indicators
RF GATEWAY - 2 WAY
PWR NET RxSIG
RF
Tx
STRFGWX
ANTENNA
CRESTRON
Operations Guide - DOC. 5811A Two-Way RF Transceiver: STRFGWX • 3