Specifications

2-Way RF Wireless Touchpanel Crestron STX-1700C

Configuring the Touchpanel

MAIN MENU

This menu can also be obtained via

digital reserved join number, 17242.

To configure the unit, it may be necessary to access a series of setup screens prior to

viewing run-time screens that are loaded into the touchpanel for normal operation.

The MAIN MENU for configuring the touchpanel appears when a finger is held for

about five seconds from the power off state.

Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four

buttons: Touch Screen Calibration, Exit and Run Program, Setup, and

Diagnostics.

Selecting Exit and Run Program verifies that all of the setup information has been

saved to EEPROM and displays the main page that has been programmed into the

touchpanel. The remaining buttons on the MAIN MENU open other menus, which

are discussed in subsequent paragraphs.

Calibration Menu

CALIBRATION MENU

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button's image. Select the Touch Screen Calibration

utton to

display the CALIBRATION MENU, as shown to the left. The CALIBRATION

MENU offers the choice to initiate calibration with the Perform Calibration button

or return to the previous screen with the Return button. Choose an option by

touching the appropriate button.

If you need to calibrate the touchpanel, the screen displays the message "Touch

Upper Left" centered on the panel with a cross hair in the upper left corner. Touch

the cross hair to initiate calibration. Another message, "Touch Upper Right", appears

with a cross hair in the correct corner. Touch the cross hair. A final message, “Touch

Lower Right”, appears with a cross hair in the correct corner. Touch the crosshair to

finish the calibration and return to the MAIN MENU.

NOTE: When touching each crosshair during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil.

Setup Menu

SETUP MENU

To obtain the SETUP MENU, shown to the left, press the Setup button from the

MAIN MENU. The SETUP MENU offers a series of buttons, which open additional

menus and screens that are detailed in subsequent paragraphs. After setup parameters

have been set, select the Return button to return to the MAIN MENU.

NOTE: For convenience, the current CRESNET ID setting is displayed in the lower

left corner.

NOTE: All touchpanel settings are automatically saved in non-volatile memory.

8 • 2-Way RF Wireless Touchpanel: STX-1700C Operations Guide - DOC. 6226A