Specifications

2-Way RF Wireless Touchpanel Crestron STX-1700C

Appendix B: Installation of Optional Pushbuttons

The STX-1700C is supplied with ten optional pushbutton switches, blank buttons,

and a bezel to accommodate the switches. As a further option, custom engraved

black buttons (1700C-BTNB) or silver buttons (1700C-BTNS) can be designed and

purchased via the Crestron Engraver software. Version 2.3.0.0 or later is available

from the Crestron website.

Perform the following to install pushbuttons on the STX-1700C. Follow these same

basic procedures to replace the blank buttons with the optional engraved buttons. A

#1 Phillips screwdriver is required. Refer to the illustration below.

1. Place the touchpanel face down on a clean work surface.

2. Remove the four screws securing the front bezel to the base. Holding the

bezel to the base, return the unit to its normal position and lift the bezel

from the base.

3. Assemble the supplied membrane switches to the pushbutton sets. Notice

that the pushbutton sets fit snugly on the membrane switches. (Refer to the

following Notes.)

4. Put the assembled pushbuttons and switches in place (refer to the following

Notes), and place the new bezel in position.

NOTE: The rear of the pushbuttons are marked 1-5 TOP and 6-10 TOP to ensure

correct orientation when installed. Do not remove the plastic frame connecting the

buttons together.

NOTE: Carefully position the switch/pushbutton assemblies on the printed circuit

boards–edges should be aligned–and place the bezel over the pushbuttons to hold

them in place.

5. Hold the bezel in position and turn the unit over on its face.

6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,

being careful not to strip the threads.

7. Verify that the pushbuttons function properly.

Optional Pushbutton Installation Diagram

Pushbuttons

Membrane

Switches

Screw

Bottom view

Bezel

• 2-Way RF Wireless Touchpanel: STX-1700C Operations Guide - DOC. 6226A