Specifications

Crestron STX-1700CXP 2-Way RF Wireless Touchpanel
Operations Guide – DOC. 6227A 2-Way RF Wireless Touchpanel: STX-1700CXP • 7
designed to provide reasonable protection against harmful interference in a
residential installation. The equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and transceiver.
■ Connect the equipment into an outlet on a circuit different from that to which the
transceiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
Setup
Applying Power
The touchpanel can be powered via the ST-BTPN, while docked in the ST-DSN, or
via the external power pack. Each of these items has its own Operations Guide which
details proper usage. Refer to the table below for the required document number.
STX-1700CXP Power Source Options
POWER SOURCE OPTION MODEL
DOCUMENT
NUMBER*
Battery Pack** ST-BTPN 6088
Docking Station ST-DSN 6095
Domestic External Power Pack, or PW-1215 5764
International External Power Pack PWI-1215 5765
* The latest revision may have a revision letter after the document number (e.g., 6088A).
** The battery pack does not “trickle” charge when the external power pack is used to power the
touchpanel.
Identity Codes
The STX-1700CXP touchpanel uses distinct types of identity (ID) codes for
recognition within a Cresnet system: Cresnet identity (Net ID) for instances when the
touchpanel is wired to the Cresnet system, and RF ID for those instances when the
touchpanel communicates with the Cresnet system via the RF gateway. These codes
are assigned to the touchpanel from the SELECT INTERFACE screen when the unit
is configured. Refer to “Select Interface” on page 9. These assignments must match
assignments made in the SIMPL Windows project.
In addition, it is necessary to specify an RF channel and band in order for the
touchpanel and TPS-RFGWX gateway to communicate. These settings, described
briefly on the next page, are assigned via the RF SETUP and ADDITIONAL RF
SETUP screens, shown on page 10.