Specifications

2-Way RF Wireless Touchpanel Crestron STX-1700CXP
22 • 2-Way RF Wireless Touchpanel: STX-1700CXP Operations Guide - DOC. 6227A
NOTE: If the control system in use has a 4-pin network connector rather than a
modular (RJ-11-type) NET connector, use an ST-CBL interface cable (sold
separately).
NOTE: To make a cable for either configuration, refer to the “Programming Cable
Specifications” diagram after these notes.
NOTE: An adapter such as a CN-RJ11 (sold separately) is required when using the
RJ-11 cable.
NOTE: The RJ-11 (part of ST-PK) and ST-CBL cables can also be found as part
numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The
database can be downloaded from the Crestron website.
NOTE: The procedure below uses the ST-CBL.
Programming Cable Specifications
1. Before making any connections to the touchpanel, verify that the
control system is properly connected to the PC (using an RS-232 DB9
straight-through cable, Crestron P/N CNSP-587) and powered on.
2. Attach the stereo connector end of the ST-CBL to the touchpanel.
3. Attach the network connector end of the ST-CBL to the connector
labeled NET on the control system.