Specifications

Media System Crestron Adagio
®
AMS
AMS Specifications (Continued)
SPECIFICATION DETAILS
Audio – Surround Sound
Processor
Processor
Analog-To-Digital Conversion
Digital-To-Analog Conversion
Supported Formats/Modes
Surround Sound Master Volume
Speaker Compensation
Low Frequency Effects (LFE)
Mode Trim (Level Preset)
Input Compensation
Mute
Bass Gain Range
Treble Gain Range
EQ Modes
PEQ Filter Gain
PEQ Filter Bandwidth
PEQ Filter Center Frequency
GEQ Filter Gain
GEQ Filter Center
Frequencies
Crossover/High-Pass Frequency
Maximum Delay
Dynamic Range (compression)
Frequency Response
Total Harmonic Distortion
(THD) + Noise
Signal-to-Noise Ratio (SNR)
Dynamic Range
Channel Separation
Texas Instruments DA610 Aureus™ 32-bit
floating point DSP w/Audysey MultEQ
®
XT
setup algorithms
24-bit 48 kHz
24-bit 48 kHz
Bypass, Stereo, 2-channel steering
(surround or rear), Multi-channel stereo,
Ambience Effects (Cathedral, Hall, Stadium,
Jazz Club), Dolby
®
Pro Logic IIx, Dolby
Digital 5.1, Dolby Digital EX, DTS Neo:6,
DTS Digital 5.1 Discrete, DTS ES 6.1
Discrete, DTS ES 6.1 Matrix, DTS 96/24
-80dB to +20dB, 0.5dB steps
±12dB, 0.5dB steps
-10dB to +0dB, 0.5dB steps
±12dB, 0.5dB steps (master); ±12dB, 0.5dB
steps (per output); -10dB to +0dB, 0.5dB
steps (LFE)
±10dB, 1dB steps
-80dB (electronic), >-100dB (relay)
±12dB, 1dB steps
±12dB, 1dB steps
Audyssey MultEQ XT or 6-band parametric
or graphic per surround/subwoofer output
channel
±12dB, 0.5dB steps
0.02 to 2.0 octaves
20Hz to 20KHz
±10dB, 0.5dB steps
50, 180, 630, 2.3k, 8k Hz
40 to 200 Hz, 10 Hz steps
100ms per channel, picture delay (lip-sync)
and speaker distance compensation
combined
Minimum, Standard, Maximum
20Hz to 20kHz ±0.01dB (preamp),
20Hz to 20kHz ±0.2dB (power amp)
<0.006% (preamp), 0.03% (power amp)
20Hz to 20kHz
>100dB (preamp), 100dB (power amp) 20Hz
to 20kHz A-weighted
>113dB
>85dB (preamp), >80dB (power amp)
(Continued on following page)
6 • Media System: Adagio AMS Operations Guide – DOC. 6509B