Specifications

Crestron Adagio
®
AMS Media System
NOTE: If using an AAE, external sources should be connected to the AAE
and looped through to the AMS. For more information, refer to the latest
version of the AAE guide (Doc. 6460), which is available from the Crestron
website.
NOTE: If using an AAE, the left and right downmix outputs of the AMS
must be connected to an input on the AAE so rooms connected to the AAE
can receive the theater downmix. For more information, refer to “Set AAE
Theater Source” on page 52.
NOTE: The AAE must be set to its default Net ID value (31). For
information on setting the AAE’s Net ID, refer to the latest version of the
AAE guide (Doc. 6460) which is available from the Crestron website.
Make the connections shown in the following diagram for the AMS to properly
control and switch connected devices while using the out-of-the-box functionality.
CAUTION: All tuner cards should be securely installed in the AMS.
CAUTION: Devices such as the AAS and the AAE must be fully grounded to the
AMS. Additionally, any other source devices should be grounded to the AMS as
well.
NOTE: The AMS can only be powered by the included power cord. Power cannot
be supplied from network devices that are connected to the mini-terminal block
connectors.
NOTE: The AMSI (International version) requires a power cord that is harmonized
to the country’s national and local electrical code. Each inner wire in the cord should
be at least 16 AWG or (1.5 mm
2
) and rated for at least 500V.The temperature rating
of the cord should be at least 60ºC. The cord length should be 1.5 meters to 2 meters.
Operations Guide – DOC. 6509B Media System: Adagio AMS • 33