Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8

•

Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D

4. Use Sonnex Tools or the SWAMP-24X8’s “Installer Mode” menu to set the

subwoofer output to Mono.

For more information, refer to “Set Mono/Stereo” on page 30 or the Sonnex

Tools help file.

5. Trim the subwoofer level using an SPL meter, the pink noise files (satellite

pink noise.wav and subwoofer pink noise.wav) found in the Sonnex Tools

help file, and Sonnex tools.

NOTE: The audio output of the PC used to configure the system should be

connected to an input on the SWAMP-24X8. The input should be routed to

the connected outputs. For information on routing signals, refer to

“

Operation” on page 44.

a. Set the SPL meter to C-Weighted, Slow Response.

b. Place the SPL meter at the listening position with the meter pointing

straight up.

c. Play satellite pink noise.wav on the left speaker.

d. Turn the volume up until the SPL meter reads 85 dB.

e. Play satellite pink noise .wav on the right speaker. The SPL meter

should read very close to 85 dB.

f. Play subwoofer pink noise.wav on the left speaker.

g. Use Sonnex Tools or the “Installer Mode” menu to adjust the bus

volume offset of the subwoofer zone until the SPL meter reads 85 dB.

For more information, refer to the Sonnex Tools help file or “Set Bus

Volume Offset” on page 32.

Connect to Expanders

The SWAMP-24X8 can be connected to an expander via shielded CAT5e cable to

increase the number of output zones, with a maximum of eight devices.

SWAMP-24X8 to SWAMPE Connection (SWAMPE-8 shown)

NOTE: When connecting a SWAMP-24X8 to an expander, Crestron recommends

using Crestron DM-CBL-8G or high-quality CAT5e shielded twisted-pair cable.

Shielded connectors such as the DM-8G-CONN must be used.