Installation guide

Docking Assembly for TPMC-10 Crestron TPMC-10-DSW
7. Secure the bezel into position using the four supplied 6-32x1/4” black
pan-head screws B using a #2 Phillips screwdriver.
8. Hold the cover plate in position and use an Allen wrench to adjust the
plate alignment screw shown in the previous illustration so the plate is
flush with the adjacent surface of the bezel. (Turn clockwise to move it
in; counterclockwise to move it out.)
9. When the position is satisfactory, attach the cover plate using the
screws removed in step 3.
10. The latch adjusting screw, identified in the previous illustration and
accessible through a slot in the bottom left corner in the bezel, is to be
used only if the latching mechanism closes too soon, preventing the
TPMC-10 from fully docking, or if the latching mechanism does not
operate when the touchpanel is pressed back into position. (Refer to
“Docking the TPMC-10” on page 12.)
Turn the screw counterclockwise a few turns if the mechanism closes
too soon; turn it clockwise a few turns if the mechanism fails to close.
The latch adjusting screw also determines whether the “Dock Open”
digital output join is set high when the panel is pressed into position. In
addition to the adjustments above, the screw should be set so that the
“Dock Open” indicator is high when the panel is docked. (Refer to the
SIMPL Windows help file (F1) for more details.)
Programming Software
Have a question or comment about Crestron software?
Answers to frequently asked questions (FAQs) can be viewed in the Online Help
section of the Crestron website (www.crestron.com). To post your own question or
view questions you have submitted to Crestron’s True Blue Support, log in at
http://www.crestron.com/accounts/login.asp. First-time users will need to establish a
user account.
You can create a program that allows you to set up the TPMC-10 to operate a
Crestron control system using the Crestron programming tools: Crestron
SystemBuilder
™ and SIMPL Windows. These tools are intended for users with
different levels of programming knowledge. The flexibility of each tool is
proportional to the degree of programming expertise (i.e., the more flexible, the
more a programmer needs to know and account for). Of course, one can initiate
programming using the easiest method (SystemBuilder) and use advanced
techniques that are available from SIMPL Windows to customize the job.
Earliest Version Software Requirements for the PC
NOTE: Crestron recommends that you use the latest software to take advantage of
the most recently released features. The latest software is available from the Crestron
website.
The following are recommended software version requirements for the PC:
• SIMPL Windows version 2.06 or later. Requires SIMPL+ Cross
Compiler version 1.1 and Library Update 352 or later.
8 • Docking Assembly for TPMC-10: TPMC-10-DSW Operations and Installation Guide - DOC. 6400