Installation guide

Crestron TPMC-8X-DSW Wall Mount Docking Station for TPMC-8X Series
3. Since the TPMC-8X-DSW contains moving parts, mounting to a stud offers more support and is
therefore highly recommended. Although Crestron offers the post-construction WMKM-8X-DSW and
WMKT-8X-DSW mounting options, a mounting option that is secured to a stud, such as the
BB-8X-DSW or PMK-8X-DSW is highly recommended.
NOTE: The following steps are performed only after the BB-8X-DSW or
PMK-8X-DSW has been installed. It is assumed the BB-8X-DSW or PMK-8X-DSW
has been secured to the stud according to the instruction in the latest Installation
Guides (Doc. 6579 and Doc. 6580 respectively). It is also assumed that drywall is in
place and a cutout for the TPMC-8X-DSW and touch screen is made in the drywall.
If the BB-8X-DSW or PMK-8X-DSW is to be used and a TPMC-8X-DSW Docking
Station is not available, the installer can either leave the hole in the mounting surface
open (if permitted by local building codes) or attach the cover plate supplied with the
mounting kit.
TPMC-8X-DSW Mounting
Tools Required: #2 Phillips tip screwdriver
1. If the cover plate is attached, use a #2 Phillips screwdriver to loosen and
remove the four screws and plate.
2. Connect all required cables to the TPMC-8X-DSW. Use the provided 2-pin
and 5-pin connectors for 24 Volt power and audio output respectively.
Refer to “Hardware Hookup” on page 10 for details.
3. Insert the TPMC-8X-DSW (without its bezel) into the mounting option and
align the four screw holes.
4. Insert and tighten the four supplied screws (finger tight and then using a #2
Phillips screwdriver, tighten an additional 1/8-turn).
5. In order for the TPMC-8X-DSW to recognize the presence of a TPMC-8X
Series touch screen, a connection must be made between the
TPMC-8X-DSW and the bezel. To connect the bezel, complete the
following procedure:
a. On the rear of the bezel’s upper right corner, locate the cable connector,
as shown in the following illustration.
TPMC-8X-DSW Bezel Cable Connector
Operations & Installation Guide – DOC. 7080B Wall Mount Docking Station for TPMC-8X: TPMC-8X-DSW • 7