Specifications

12 Inch Tilt/Lectern Touchpanels Crestron TPS-4500V & TPS-4500LV

that is required to protect the equipment. Using non-Crestron cables will result in

damage to the product.

This 10-pin RJ-45 port provides network connection from the touchpanel to the

interface module and network power to the touchpanel. This port also contains the

composite and S-video connections for supplying video signals to the touchpanel

from the interface module. Refer to the descriptions and pinout table that follow this

paragraph.

Pin Assignments

TYPE PIN DESIGNATION DESCRIPTION

1 +24V Power (Network)

2 GND Ground (Network)

3 C+ Chrominance (Positive) /Composite 2

4 C- Chrominance (Negative) /Composite 2

5 Y Data (Network)

6 Z Data (Network)

7 Y+ Luminance (Positive)/Composite 1

8 Y- Luminance (Negative)/Composite 1

9 GND Ground (Network)

10-pin RJ-45

Pin 1

10 +24V Power (Network)

To determine the location of pin 1, hold the cable so that the end of the 10-pin RJ-45

connector is facing away from you, with the clip side down and the copper side up.

The copper connector on the far left is pin 1.

24 VDC, 2.0A (Power Supply for TPS-4500V)

This female connector is used to supply 24 VDC power to the TPS-4500V or the

TPS-4500IMPC from an optional power pack (Crestron model PW-2420RU). When

power is supplied to the TPS-4500IMPC through this connector, a Cresnet power

connection is not required to display video on the touchpanel.

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to

do so could cause equipment damage or void the Crestron warranty.

CAUTION: If power is provided to the TPS-4500V from the +24VDC on a Cresnet

connector or the optional PW-2420RU to the touchpanel base, power must not be

applied to the power input on the TPS-4500IMPC.

NOTE: Use care in wiring installations to avoid applying 24 VDC power to Cresnet

wiring from multiple sources.

Video

Composite or S-video signals are supplied to the TPS-4500V via the

TPS-4500IMPC. The TPS-4500IMPC can accept balanced video signals using

CAT5 wiring or unbalanced signals using the BNC connectors. Refer to the

following diagram to make video connections to the TPS-4500IMPC.

18 • 12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV Operations Guide - DOC. 6160