Specifications

Crestron TPS-4500V & TPS-4500LV 12 Inch Tilt/Lectern Touchpanels
Video Connections
21
COAX
BAL
RS-232 NET/VIDEO 24VDC 2.0A
10-PIN
NET/VIDEO CABLE
CONNECT TO
VIDEO SOURCE
TPS-4500V
TPS-4500IMPC
CONNECTED
TO CRESNET
To display video, Cresnet power
or 24VDC MUST be connected
to the TPS-4500IMPC.
NOTE:
NTSC/PAL VIDEO
TO PANEL
VIDEO
NET/
C Y
COMP1COMP2
S+ -- S+
TPS-4500IMPC
CRESTRON
24 Y
COMP1 COMP2
C
NET
GZY
24VDC
2.0A
SOURCE SELECTION
SWITCHES
NOTE: The source selection switches must be set to “BAL” if CAT5 wiring is used
or “COAX” if the BNC connectors are used.
NOTE: For additional information on video connections over CAT5, refer to the
latest version of the Crestron CAT5 Wiring Reference Guide (Doc. 6137) which is
available from the Downloads | Product Manuals section of the Crestron website
(www.crestron.com
).
After connecting the video cables to the proper connector, the appropriate source
selection switches must be set and the video input must be set in the Video Menu.
Refer to the latest revision of the TPS-4500IMPC Interface Module Operations
Guide (Doc. 6163, included with the TPS-4500V touchpanel) and “Video Menu” on
page 13 for more information.
Touchpanel Mounting Options for TPS-4500LV
Back Box Mounting
Back box mounting is typically used at new construction sites. The optional back
box, BB-5000, includes the necessary hardware, brackets and electrical box, which
provides a secure enclosure that can be fastened directly to a stud. The details for this
optional mounting method are provided in the latest revision of the BB-5000
Installation Guide (Doc. 5827). After completing the steps in the installation guide,
simply mate the four posts of the bezel with the holes drilled into the mounting
surface and firmly press the bezel over the touchpanel.
NOTE: The mounting hardware and accessories supplied with the TPS-4500LV are
not required for the back box mounting option.
Operations Guide - DOC. 6160 12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV • 19