Specifications

Crestron TPS-XVGA RGB Computer Interface Card for TPS/Tilt Panel
Operations & Installation Guide - DOC. 5944 RGB Computer Interface Card for TPS/Tilt Panel: TPS-XVGA •• 11
13. Position the touchpanel base cover onto the base.
14. Hold the touchpanel base cover in place and position the
touchpanel face-down onto a padded surface to prevent
scratching of the screen.
15. Re-install the eight base cover screws to finger-tight then,
using a #1 Phillips screwdriver, tighten an additional 1/8-turn.
NOTE: The TPS-IMC or optional TPS-IMW serves as an interface for
the touchpanel. To connect the audio from the source computer to the
touchpanel, consult the TPS-IMC or TPS-IMW Operations Guide (Doc.
5856 or 5857, respectively). The latest revision can be obtained from the
Products page (PRODUCT MANUALS section) or Downloads page
(MANUAL Library) of Crestron’s website (www.crestron.com). New
users are required to register to obtain access to the FTP site.
16. Refer to the diagram below. At the rear of the touchpanel base,
attach a computer video cable (not supplied) from the computer
video port to the RGB port of the touchpanel. If applicable,
attach the audio cable connector from the TPS-IMC or optional
TPS-IMW to the AUDIO port of the touchpanel.
Installation Diagram 7 of 7 - Attach Computer Video Cable & Audio Cable
HEADPHONES AUDIO LANRS-232 24VDC 2.0A
AUDIO CABLE,
IF APPLICABLE
COMPUTER
VIDEO CABLE
NET/VIDEO RGB
17. Re-connect any cables that were disconnected in step 2 to the
appropriate ports on the rear of the touchpanel base.
18. If the optional external power pack is utilized, connect the
output plug of the power pack to the 24VDC 2.0A port on the
rear of the touchpanel base.